VHF Z4 - Page 28

CAD/CAM integration: Data transfer folder
label.
Setting up exocad ChairsideCAD
1.
In Windows
®
Explorer, open the exocad Chair-
sideCAD folder.
2.
Change into the
config
folder.
3.
Open the following file with a text editor:
settings-chairside.xml
4.
Inside the file, find the following expression
(“tag”):
<NestingInterop2TemporaryFolder>
Directly behind the expression, you will find the
exocad output path.
5.
Replace the output path with the letter of the net-
work drive that you recorded followed by a colon
(:).
Example: You recorded the drive letter
Z
. The
expression in the XML file must be (without
line breaks):
<NestingInterop2TemporaryFolder>
Z:
</NestingInterop2TemporaryFolder>
6.
Save and close the XML file.
Dental Wings Chairside CAD
This CAD application uses a designated shared data
folder on the CAM computer for sending jobs to the
machine. The folder is already created and shared at
delivery.
Folder path on the CAM computer:
C:\CADshare\DentalNestingObjToMDW
C:
is the local hard drive on the CAD computer.
After integration, the
CADshare
folder will be access-
ible from the CAD computer via a network drive.
Integration overview:
1.
Download the integration script from the fol-
lowing internet address to the CAD computer:
dentalportal.info/downloads
2.
Run the script on the CAD computer. Enter the
required information.
3.
Store the path to the shared data folder on the
CAM computer in DentalCNC.
4.
Store the path to the shared data folder on the
CAD computer in Dental Wings Chairside CAD.
The integration in detail:
Configuring the CAD computer
1.
Access the CAD computer.
2.
Open an internet browser.
3.
Enter the following address into the address bar:
dentalportal.info/downloads
4.
Scroll down until you reach the
Z series
section.
5.
Download the CAD/CAM integration script to the
CAD computer.
The script is stored on the CAD computer inside a
ZIP file.
6.
Unpack the ZIP file (e.g. to the Desktop).
The script file is stored under the following
name:
Install_CADshare.bat
7.
Run the script.
A window opens. The script prompts you to
enter the machine serial number.
8.
Enter the machine serial number. Press .
Ž
Location of the identification plate  serial
number
– on page13
Original Operating Instructions:Z4
Version: 12/5/2018
Z4 – Installing the machine
EN 28