Victory 2009 VISION User Manual

121
OPERATION
Operation
Cruise Control Operation - Setting
To set the cruise control (if equipped):
1. Turn the cruise control power switch ON.
2. Accelerate to the desired speed and press the
SET button. This speed will be logged in memory.
3. The CRUISE indicator lamp on the display will
illuminate.
Cruise control notes:
•
Cruise control can be set in any gear.
• The cruise control can be activated between
speeds of 25-95 mph (40-153 kph).
• Set speed will vary slightly in hilly terrain.
• The cruise control will not resume a pre-set speed if
the resulting accel / decel rate is too high or too
low. Example
: If you are in 6th gear and try to
resume a set speed from 40mph, the cruise may
disengage.
•
Brake lights must be working properly.
Right Handlebar
Set
On
visionownersmanual.book Page 121 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches