Victory 2009 VISION User Manual

202
MAINTENANCE
Maintenance
Troubleshooting
For your personal safety, do not attempt inspection or repairs not fully described in this
Rider’s Manual. Contact an authorized VICTORY dealer for service if you cannot
determine the cause of a problem or if the inspection / repair exceeds your mechanical
ability or tool resources. Do not perform any inspection or repair with the engine running.
Engine Cranks But Will Not Start
Possible Cause Possible Remedy/Action
Low Fuel Verify fuel level
Fuel pump inoperative Turn engine STOP switch to RUN. Turn key
ON. The fuel pump should run momentarily and
then stop. If you do not hear the fuel pump run,
check the fuel pump / ignition circuit breaker
(see page 186). Note: A momentary clicking
sound from the IAC valve is normal when key is
first turned to the OFF position.
Battery Discharged Fully charge the battery (page 180).
Spark Plug(s) Fouled Inspect spark plugs (page 177).
Spark Plug Wire(s) Disconnected or Loose Be sure spark plug wires are securely fastened.
visionownersmanual.book Page 202 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches