Victory 2009 VISION User Manual

125
OPERATION
Operation
Stopping The Engine
Before stopping the engine, bring the motorcycle to a complete stop either in neutral or
with the clutch disengaged. Once the motorcycle is at a complete stop, if it is not already in
neutral, shift into neutral. To stop the engine, set the engine STOP/RUN switch to the
STOP position, turn the ignition switch to the OFF position, and remove the ignition key
.
NOTE: A momentary clicking noise from the Idle Air Control (IAC) valve is normal when the ignition
key is turned to OFF.
WARNING
• Stopping the engine while the motorcycle is in motion and the transmission is engaged
may damage the engine and the transmission or cause the rear wheel to lose traction. In
either case, you could lose control.
• If the motorcycle is in motion and the engine stops on its own, guide the motorcycle to a
safe location off the road and away from traffic.
visionownersmanual.book Page 125 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches