Victory 2009 VISION User Manual

171
MAINTENANCE
Maintenance
Rear Brake Fluid
Review Brake Fluid Precautions on page 168.
1. Set vehicle upright on a level surface and view the
rear brake fluid reservoir through the right leg fairing.
2. The fluid level must be between the MIN and MAX
level lines on the reservoir.
3. If level is low, check brake pads for wear (page 96).
If pads are not worn past the service limit, inspect
the rear brake system for leaks.
4. To add fluid, remove reservoir cover with diaphragm
by turning it counter-clockwise (as viewed from top).
5. Add DOT 4 Brake Fluid from a sealed container to
the proper level. Reinstall the cover and diaphragm
and install the cover securely. Wipe cap area clean
to remove any brake fluid.
6. Check for signs of brake fluid leaks around hoses,
fittings, reservoir, and brake calipers.
Check for deterioration of hoses.
MIN
MAX
8maintenance.fm Page 171 Tuesday, February 3, 2009 12:58 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches