Victory 2009 VISION User Manual

224
STORAGE
Storage
Removal From Storage
1. Remove the cover and unlock the front forks (if locked).
2. Check the tire pressure (page 176) and inflate the tires if necessary.
3. Install the battery (page 183) and perform an electrical check (page 86).
4. Wash and polish the motorcycle. See page 207.
5. Check the oil level. Look at the storage area for signs of fluid leaks, and check the
cause if a leak is found.
6. During storage, temperature and humidity changes can cause condensation to form in
the crankcase and mix with engine oil. Running the engine with oil that contains
condensation can cause engine damage. If your motorcycle was stored in an area
subject to wide swings in temperature and humidity (such as outdoors), it is
recommended that you change engine oil prior to running the engine.
7. Install new spark plugs if necessary.
8. Wax, polish, or apply protectant to appropriate components. See page 207.
9. Perform the pre-ride checks beginning on page 85.
10. Road test the motorcycle before returning it to regular use (page 200).
visionownersmanual.book Page 224 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches