Victory 2009 VISION User Manual

86
PRE-RIDE CHECKS
Pre-Ride
Check Electrical Equipment
Turn the ignition key to the ON position and move the stop/run switch to RUN before
performing the following electrical inspections. Return the ignition key to the OFF position
after completing these inspections. If inspection of any electrical item reveals component
failure, repair or replace the component before operating the motorcycle.
Item Inspection Procedure
Headlamp Tap the starter button to verify that the headlamp illuminates. Switch to high
beam. Verify that the high beam indicator comes on and that lamp brightness
increases.
Taillight/Brake Light Verify that the taillight and license plate light illuminate. If a turn signal is
activated, only the two lower lamps will illuminate. Verify that the taillight
lamps increase in brightness when the front brake lever is applied and also
when the rear brake pedal is applied.
Turn Signals Move the turn signal switch to the left. Verify that front and rear left turn
signals flash, as well as the corresponding light on the indicator panel. Push
the switch inward to cancel the signal. Verify that the signals and the indicator
light stop flashing. Repeat the procedure for the right turn signals.
visionownersmanual.book Page 86 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches