Victory 2009 VISION User Manual

132
MAINTENANCE
Maintenance
First Service
Perform the first service after you’ve ridden your new motorcycle approximately 500 miles
(800 kilometers). This maintenance is one of the most important services your motorcycle
requires and should be performed by an authorized VICTORY dealer. Initial maintenance
includes all required adjustments, inspection or tightening of all fasteners, and an engine
oil and filter change. Performing maintenance at the required mileage point helps ensure
maximum performance and service life of your motorcycle.
Periodic Maintenance
Use the following Periodic Maintenance Interval table to determine how often you should
perform maintenance on various components. For additional information on maintenance
operations for each component listed in the table, refer to the instructions in this section
and review all warnings beginning on page 130 before performing any maintenance on
your motorcycle. If you have any doubt as to your ability to safely and correctly perform
any procedure outlined in this Rider’s Manual, whether due to the lack of knowledge,
mechanical skill, or the proper equipment, contact your VICTORY dealer to have the work
performed.
visionownersmanual.book Page 132 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches