Victory 2009 VISION User Manual

169
MAINTENANCE
Maintenance
Clutch Fluid
Review Brake Fluid Precautions on page 168.
1. Set the vehicle upright on a level surface and
turn handlebars until top of reservoir is level.
2. View the fluid level through the sight glass.
3. If level is low, check hoses, lines, and slave
cylinder (on left rear of crankcase) for leaks.
4. To add fluid, remove the three reservoir cover
screws, cover, and diaphragm.
5. Add DOT 4 Brake Fluid from a sealed container
to the proper level. Reinstall the cover and
torque screws to 25 lb-in. (3 Nm). Wipe cap
area clean to remove any brake fluid.
6. Check for any signs of clutch fluid leaks around
the hoses, fittings, fluid reservoir, and slave
cylinder. Check for deterioration of hoses.
Minimum Level
Slave Cylinder
visionownersmanual.book Page 169 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches