Victory 2009 VISION User Manual

20
SAFETY
Safety
Modifications
Modifying the motorcycle by removing any equipment or by adding equipment not
approved by VICTORY may void your warranty. Such modifications could make the
motorcycle unsafe to ride and could result in severe injury to operator or passengers, as
well as damage to the motorcycle. Some modifications may also be illegal in some states.
If in doubt, contact your authorized VICTORY dealer.
Parking The Motorcycle
When leaving the motorcycle unattended, turn the engine off and lock the steering (see
page 48.) Remove the ignition key. Park in a well lit area to discourage thieves.
Park the motorcycle where people are not likely to touch the hot engine or exhaust system
or place combustible materials in close proximity to these hot areas. Do not park near a
flammable source such as a kerosene heater or an open flame, where hot components
could ignite combustible materials.
Park the motorcycle on a firm, level surface. Sloped or soft surfaces may not support the
motorcycle when it’s parked, and it may tip over. If you must park on a slope or soft
surface, follow the precautions outlined on page 126.
visionownersmanual.book Page 20 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches