Victory 2009 VISION User Manual

21
SAFETY
Safety
Accessory Selection and Installation
Because VICTORY cannot test and make specific recommendations concerning every
accessory or combination of accessories sold, the operator is responsible for determining
that the motorcycle can be safely operated with any accessories or additional weight. Use
the following guidelines when choosing and installing accessories:
• Do not install accessories that impair the stability, handling or operation of the
motorcycle. Before installing an accessory, be sure that it does not:
- Reduce ground clearance when the motorcycle is either leaned or in a vertical position.
- Limit suspension or steering travel or your ability to operate controls.
- Displace you from your normal riding position.
- Obscure lights or reflectors.
• Bulky or large accessories can cause instability (due to the lifting or buffeting effects of
wind) and loss of control.
• Do not install electrical accessories that exceed the capacity of the motorcycle’s
electrical system. Never install higher wattage light bulbs than those supplied as original
equipment. An electrical failure could result and cause hazardous loss of engine power
or lights, or damage to the electrical system. See page 198 for more information.
• Use only genuine VICTORY accessories designed for your model.
visionownersmanual.book Page 21 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches