Victory 2009 VISION User Manual

200
MAINTENANCE
Maintenance
Lifting The Motorcycle
Some procedures such as tire removal, and steering, fork, swingarm, or axle inspection
require lifting of the motorcycle to remove weight from the component being inspected.
The motorcycle can be elevated by placing a stable, flat platform jack or lift mechanism on
a firm flat surface and lifting under the engine crankcase. The platform should be a
minimum 12 inches square. DO NOT attempt to lift the motorcycle without proper
equipment or without properly securing the motorcycle so it cannot tip or fall when
elevated.
Road Test
Before returning the motorcycle to regular use, road test it in a safe area. Pay special
attention to the proper fit and operation of all serviced components.
Make any corrections or additional adjustments as necessary to ensure safe, reliable, and
enjoyable vehicle performance.
WARNING
Care should be taken to be sure the motorcycle will not tip or fall while elevated or while on
the sidestand. Serious injury or death can occur if the motorcycle tips or falls.
visionownersmanual.book Page 200 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches