Victory 2009 VISION User Manual

87
PRE-RIDE CHECKS
Pre-Ride
Check Electrical Equipment (Cont.)
Item Inspection Procedure
Emergency
Flashers
Press the top of the hazard switch to turn the flashers on. Verify that all four
turn signals flash, as well as the lamps on the indicator panel. Turn the
flashers off. Verify that all signals and indicator lamps stop flashing.
Horn Press the horn button. Verify that the horn sounds loudly.
Neutral Indicator Place the transmission in neutral. Verify that the neutral indicator lamp
illuminates and that the letter “N” displays in the gear position display.
Low Oil Pressure
Indicator
Verify that the low oil pressure lamp illuminates. Start the engine and verify
that the low oil pressure lamp goes off.
Engine Stop/Run
Switch
Start the engine. Move the stop/run switch to the STOP position. Verify that
the engine stops. Attempt to restart the engine to verify that the engine WILL
NOT start.
visionownersmanual.book Page 87 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches