Victory 2009 VISION User Manual

127
OPERATION
Operation
Reverse
NOTICE: Do not attempt to engage or disengage the reverse system when the motorcycle is
moving.
NOTE: The starter system will not function if the reverse lever is engaged. If the reverse system
fuse blows, the starter button will not function even if the reverse lever is disengaged. The
fuse must be replaced. See “Fuse Replacement” on page 186.
BEFORE operating in reverse NEVER operate in reverse
• always sit on the motorcycle with legs astride
and both feet on the ground.
• always check for obstacles or people behind
the motorcycle.
• always retract the sidestand fully.
• always make sure the motorcycle is not
moving.
• when you are not seated in a normal
operating position
• when in an area where obstacles or
bystanders are present.
• with a passenger on board. A passenger can
obstruct your view and maneuverability.
• on loose or slippery surfaces. Loss of foot
traction could cause a tip-over.
• when the motorcycle is moving.
• on a grade or uneven surfaces.
visionownersmanual.book Page 127 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches