Victory 2009 VISION User Manual

152
MAINTENANCE
Maintenance
Drive Belt / Rear Wheel Alignment
1. Look at the alignment reference marks (3) on
each side of the swingarm and the marks (4) on
the axle plates to verify proper wheel alignment.
Axle plate mark to reference mark alignment
must be the same on both sides.
2. If the marks are not aligned, perform all steps of
the Belt Tension Adjustment procedure
(page 151).
3. Before and after tightening the axle nut, verify
belt tension and wheel alignment are both
correct.
3
4
visionownersmanual.book Page 152 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches