Victory 2009 VISION User Manual

190
MAINTENANCE
Maintenance
Seat Removal / Installation
To remove the seat:
1. Open the glove compartment door and fuel door.
2. Lift the console trim panel straight upward at each
corner to remove it. Do not tip the panel backward.
3. Remove the two seat bolts (4mm Allen).
4. Lift the front of the seat upward and pull forward to
disengage the tab at the rear of the seat.
5. To install, reverse the above process, being sure to
engage the tab at the back of the seat.
6. Torque seat bolts to 36 lb-in (4 Nm).
Seat Bolts
visionownersmanual.book Page 190 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches