virtual access GW2024P-2 User Manual

25: Automatic operator selection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 191 of 350
Web: Protocol of the new interface
UCI: network.[..x..].proto
Opt: proto
Protocol type. Select LTE/UMTS/GPRS/EV-DO.
Option
Description
Static
Static configuration with fixed address and
netmask.
DHCP Client
Address and netmask are assigned by DHCP.
Unmanaged
Unspecified
IPv6-in-IPv4
(RFC4213)
IPv4 tunnels that carry IPv6.
IPv6 over
IPv4
IPv6 over IPv4 tunnel.
GRE
Generic Routing Encapsulation.
IOT
L2TP
Layer 2 Tunnelling Protocol.
PPP
Point to Point Protocol.
PPPoE
Point to Point Protocol over Ethernet.
PPPoATM
Point to Point Protocol over ATM.
LTE/UMTS/
GPRS/EV-DO
CDMA, UMTS or GPRS connection using an
AT-style 3G modem.
Web: Create a bridge over multiple
interfaces
UCI: network.[..x..].typeOpt: type
Enables bridge between two interfaces.
0
Disabled.
1
Enabled.
Web: Cover the following interface
UCI: network.[..x..].ifname
Opt: ifname
Select interfaces for bridge connection.
Table 63: Information table for the create interface page
Click Submit. The Common Configuration page appears.
Figure 101: The common configuration page

virtual access GW2024P-2 Specifications

General

Brand	virtual access
Model	GW2024P-2
Category	Wireless Router
Language	English