27: Configuring firewall
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 249 of 350
Web: Internal port
UCI: firewall.<redirect
label>.dest_port
Opt: dest_port
Specifies the destination tcp/udp port for the redirect traffic.
Web: Enable
UCI: firewall.<redirect
label>.enabled
Opt: enabled
Specifies if this redirect should be enabled or disabled.
Table 85: Information table for firewall port forward settings
The defined redirects can be sorted into a specific order to be applied. More specific rules
should be placed first.
After the redirect is created and saved, to make changes, click Edit. This will provide
further options to change the source/destination zones; specify source mac addresses
and enable NAT loopback (reflection).
Figure 130: The firewall – port forwards – forward edits page
To Next Page
Loading...
Need help?
General