Visonic POWERMASTER 10 - Electrical Appliance Control

D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide 19
CONNECTING AC POWER USING INTERNAL AC/DC POWER SUPPLY UNIT
PERFORM STEPS 1, 2 & 3 ON A WORKBENCH BEFORE THE MOUNTING
8
7
B
C D
E
2
3
5
1
4 6
A
1.
Extract either plastic segment (will be used later)
7. Fasten power cable by clamp (extracted in step 2)
2.
Extract plastic segment (will be used later)
8. Close power supply terminals cover
3.
Knock out the
plast
ic segment (left or right,
according to the power wiring direction)
4.
Remove power supply terminals cover (E)
A. Internal AC/DC power supply unit
B. Power cable clamp options
C. For thin cable
D. For thick cable (reversed clamp)
E. Terminals cover
5.
I
nsert the power cable through the desired wiring
channel, route it to the power supply unit and
connect its 2 wires to the power supply terminal
block with a screwdriver. Fasten the screws tightly.
Verify that the wires are properly fastened!
6.
Insert p
lastic cap to the power cable entry
(extracted in step 1)
Figure 3.11 – Power Cable Wiring