D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide 71
Option Instructions
Here you can record a message to be announced automatically when events are
reported to private telephones.
While in , press to initiate the recording procedure.
Press the button continuously to record your message;
appears momentarily and then changes to (the square boxes
slowly disappear, one by one, until the end of the recording time).
At the end of the recording process, the panel will display the following:
. Release the button.
Note: To check the recorded message, press the button and listen to the
playback.
To advance to the next stage in the recording procedure; from the menu, click .
Option Instructions
Here you can record ten user names and assign them to users 23-32. In case of
event, the relevant user name will be added to the message that will be reported via
the telephone.
Record user names for 23-32; the procedure is identical to the "HOUSE IDENTITY"
recording procedure described above.
Click to navigate between user name numbers.
Here you can record user terms 1- 5 (for example, Living room, Library, etc.), and
assign them to specific zones. These names are useful if none of the 26 fixed zone
names are found suitable for a certain zone. When done, press to return.
Record user terms 1-5; the procedure is identical to the "HOUSE IDENTITY"
recording procedure described above.
Click to navigate between user term numbers.
3.8.3 Voice Box Mode
∗
∗∗
∗
This mode allows you to determine whether two-way voice communication is to be sounded either via an
external speakerphone, via the control panel, or via both.
For the two-way voice communication procedure, follow the instructions below. Additional details and guidance
are provided in section 3.2.
To select the option you wish, enter the menu, select the option you wish to perform (see
guidance above), then refer to the table below which provides you with the options.
Define whether two-way voice communication is to be sounded either via the external
speakerphone ("VOICE BOX ONLY"), via the control panel ("NO VOICE BOX"), or
via both ("VOICE BOX MIXED").
Option settings: NO VOICE BOX (default); VOICE BOX ONLY and VOICE BOX
MIXED
∗
Refers to PowerMaster-30 only
To Next Page
Loading...
Need help?
General
