Visonic POWERMASTER 10 - Correcting Trouble Situations

24 D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
2.3.6 GSM Module Installation
Fasten the GSM module as shown in Figure 3.17.
A. GSM
B. Front unit
Caution! Do not install or remove the GSM module
when the system is powered by AC power or
backup battery.
B
A
Figure 3.17 –Optional GSM Module Mounting
Inserting the SIM card into the GSM
module (see Figure 3.18).
1. Slide top cover.
2. Open cover
3. Align SIM card in cover (note
cover orientation)
4. Slide SIM card into cover
5. Rotate cover to close
6. Lock cover to close
IMPORTANT! Do not insert or
remove SIM card when the control
panel is powered by AC power or
battery.
2
3
6
4
5
1
Figure 3.18 – SIM Card Insertion
2.3.7 PGM-5 Installation
PGM-5 is an output interface module designed to provide alarm, trouble events and status signals to external
devices such as long range wireless monitoring transmitters, CCTV systems, home-automation systems and
LED annunciation panels (for further details see the PGM-5 Installation Instructions).
The PGM-5 provides 5 solid state relay contact outputs and is designed to be used as a plug-in internal add-on
module with the PowerMaster-30 control panel.
Note: The PGM-5 will be active only if the PGM-5 option was enabled in the factory default of the control panel.