Visonic POWERMASTER 10 - Testing Wireless Devices

D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide 73

 – Configuring an option from the "Diagnostics" menu
To Select an Option:
[1]
Enter the Installer Menu and select the option (see section 4.2).
[2]
Select the sub-menu option you need, for example: .
[3]
Select the diagnostic function you wish to perform, for example: .
3.9.2 Testing Wireless Devices
The PowerMaster enable to test the wireless devices attached to the panel. You can test all devices, one device
at a time, display devices' status and review RF problems, in case of any.



Means
scroll
and
select
To select the option you wish, enter the menu, select the option you wish to perform (see
guidance above and in section 4.8.1), then refer to the table below which provides you with detailed
explanations for each option.
Option Instructions
Here you can test all devices automatically, one after the other.
While in , press to initiate the test.
The devices are tested in the following order: wall-mounted devices, keyfobs and
handheld devices.
At the end of the test process, the panel will present the following:
. Press to view devices' status.
Note: Refer to section for further information on device status.
Pressing any key during the testing process will open the following options:
1. Press to jump to the next device group. For example, from wall-mounted
devices to keyfobs.
2. Press to continue the testing process
3. Press to exit the test process.
While in the handheld devices test process, indicated by the corresponding display,
for example, "TEST KEYFOBS 01", press any key of the selected handheld device to
initiate the test.
Here you can select a specific device you wish to test (Contact Sensors, Motion
Sensors, Glassbreak Sensors, Smoke Sensors, CO Sensors, Gas Sensors, Flood
Sensors, Temperature Sensor, Keyfobs, Keypads, Sirens or Repeaters).
Press to enter the sub menu and use to scroll through
the device families. Press to enter the sub menu For
example: .
The following screens will appear: 


Where Zxx indicates the device zone number.
If there is no device, the following screen will appear: .
Press
to test the selected device. The following screen will appear:
MOTION SENSORS
07.DIAGNOSTICS
OPTION you wish
WL DEVICES
WL DEVICES
07.DIAGNOSTICS
WL DEVICES
TEST ONE DEVICE
TEST ALL DEVICES
SHOW ALL DEVICES
TEST ONE DEVICE
CONTACT SENSORS
MOTION SENSORS
GLASSBREAK SENS.
TEST ONE DEVICE
< device family >
Zxx:<device name>
< location >
NO EXISTING DEV.
TEST ALL DEVICES
SHOW ALL DEVICES