74 D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
.
While in the handheld devices test process, indicated by the corresponding display,
for example, "TEST KEYFOBS 01", press any key of the selected handheld device to
initiate the test.
At the end of the test process, the panel will present the devices' status:
Note: Refer to section for further information on device status.
Here you can view the devices status.
Note: This option is available only after testing process was done.
Press to view the devices' status.
The following screens will appear:
* The signal strength indications are as follows: "STRONG"; GOOD"; "POOR"; "1-
WAY" (the device operates in 1-way mode, or, the "NOW" communication test failed);
"NO COM." (no communication); "NOT TST" (results are shown without any
performed test); "NOT NET" (device is preenrolled – not networked); "NONE" (keyfob
24Hr result); or "EARLY" (result of the last 24Hrs without statistics).
Use to scroll between the device's families.
Here you view only the devices which have RF problems.
Note: This option is available only after testing process was done.
Press to view the devices' status.
The following screens will appear:
* The signal strength indications are as follows"POOR"; "1-WAY" (the device
operates in 1-way mode, or, the "NOW" communication test failed); "NO COM." (no
communication); "NOT TST" (results are shown without any performed test); "NOT
NET" (device is preenrolled – not networked); "NONE" (keyfob 24Hr result); or
"EARLY" (result of the last 24Hrs without statistics).
Use to scroll between the device's families.
3.9.3 Testing the GSM module
The PowerMaster enable to test the GSM module integrated inside the panel.
To start the GSM diagnostic process, enter the menu, and press to initiate the test.
Upon test completion, the PowerMaster10 / PowerMaster-30 will present the test result.
Zxx: NOW: <status>*
TESTING Zxx NNN
To Next Page
Loading...
