D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide 55
– Entering the "Communication" Menu
To Select an Option:
[1]
Enter the Installer Menu and select the "04.COMMUNICATION" option (see section 3.2).
[2]
Select the sub-menu option you need, for example: "3: C.S. REPORTING".
[3]
Select the parameter you wish to configure for example: "11:RCVR 1 ACCOUNT"
[4] To continue, go to the section of the selected sub-menu option, for example section 3.6.4 for the
"3:C.S.REPORTING" sub-menu, and look for the option you wish to configure (e.g. "11:RCVR 1 ACCOUNT").
After configuring the selected parameter the display returns to step 3.
To Change the Configuration of the Selected Option:
When entering the selected option, the display shows the default (or the previously selected) setting marked
with ().
If you wish to change the configuration, scroll the "Option settings" menu and select the setting you
wish and press to confirm. When done the display brings you back to Step 3.
3.6.2 Configuring PSTN (Landline or Telephone Line) Connection
The PowerMaster-10 / PowerMaster-30 panels include a telephone dialer for reporting to Monitoring Stations
using Alarm Formats (see section 3.6.4 option 41) and to Private Telephones (see section 3.6.5 "VOICE
REPORT"). Here you configure necessary parameters related to the PSTN telephone line to which the
PowerMaster-10 / PowerMaster-30 is connected.
To configure an option enter the menu, select the option you wish to configure (see
guidance above and in section 3.6.1), then refer to the table below which provides you with detailed
explanations and configuration instructions for each option.
Option Configuration Instructions
In some older PSTN networks, it may not be possible to dial from the control panel to
other PSTN telephone numbers (such as monitoring stations or private phones), if the
dialed number contains an area code which is identical to the area code of the panel
(i.e. both the panel and the other numbers are in the same PSTN area code).
If you encounter the same problem with the PSTN network the panel is connected to,
you must enter here the area code of the PSTN telephone line to which the panel is
connected (up to 4 digits) so that when dialing to other PSTN phone numbers
programmed with the same area code, the PowerMaster-10 / PowerMaster-30 will skip
the area code from the dialed number.
Here you enter the prefix digit (if necessary) for the system to access an outside
telephone line.
Here you determine the dialing method used by the PSTN dialer of the PowerMaster-10
/ PowerMaster-30 control panel.
Option settings: pulse and tone (dtmf) (default).
To Next Page
Loading...
