EasyManuals Logo

Visonic POWERMASTER 10 Installer's Guide

Visonic POWERMASTER 10
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
72 D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
3.9 Diagnostics
3.9.1 General Guidance – "Diagnostics" Flow-Chart & Menu Options
The DIAGNOSTICS menu enables you to test your system and to verify proper operation of your PowerMaster
panel, wireless devices attached to it and the communication (GSM/GPRS) modules.
IMPORTANT! Reliable reception must be assured during the initial testing and also throughout subsequent
system maintenance. A device should not be installed in location where signal strength is "poor". If you
get "poor" signal strength from a certain device, simply re-locate it and re-test until a "good" or "strong" signal
strength is received. This principle should be followed throughout the diagnostic test procedure.
The diagnostic test process is shown below.
The menu contains several sub-menu options, each covering a group of configurable
features and parameters related to the communication and reporting as follows (see detailed list in Step-3 of the
chart below):
Option Description of Option Features and Parameters Section
Describes how to test the devices attached to the PowerMaster panel,
review devices' status and RF signal status. You can test all devices, test
single device, review devices status and review RF problems, in case of
any.
4.8.2
Describes how to test the GSM/GPRS communication module. 4.8.3
To enter the menu and to select and configure an option, proceed as follows:
Step 1
Step 2
Step 3
Step
4
Select
[1] Select Diagnostics
Sub-menu option
[2] Select the diagnostics you want to perform [3]
[4]
See
section
4.8.2
4.8.3
WL DEVICES
GSM/GPRS
07.DIAGNOSTICS
07.DIAGNOSTICS
07. DIAGNOSTICS
INSTALLER MODE
07. DIAGNOSTICS WL DEVICES TEST ALL DEVICES
SHOW ALL DEVICES
SHOW RF PROBLEMS
TEST ONE DEVICE Contact sensors
Motion sensors
Repeaters
GSM/GPRS

Table of Contents

Other manuals for Visonic POWERMASTER 10

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Visonic POWERMASTER 10 and is the answer not in the manual?

Visonic POWERMASTER 10 Specifications

General IconGeneral
Communication ProtocolsPowerG
Frequency433-434 MHz, 868-869 MHz
System TypeWireless
CommunicationGSM
Remote ControlYes
Event Log1000 events
Partitions3
Humidity85% non-condensing
User Codes8
Backup BatteryNi-MH battery pack
Operating Temperature-10°C to +50°C

Related product manuals