Visonic POWERMASTER 10 - Modifying or Reviewing a Device

D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide 41

 – Deleting a Device
[1]
Enter the Installer Menu, select the "02.ZONES/DEVICES" option (see section 3.2) and then select the
"DELETE DEVICES" option.
[2]
Select the respective Group of the device you wish to delete i.e. "CONTACT SENSORS", "MOTION SENSORS",
"GLASSBREAK SENS.", "SMOKE SENSORS", "CO SENSORS", "GAS SENSORS", "FLOOD SENSORS",
"TEMPERATURE SENS", "WIRED SENSORS", "TAGS(Proximity)", "KEYFOBS", "KEYPADS", "SIRENS" and
"REPEATERS". For example, "MOTION SENSORS".
[3] Scroll the Device Group, identify (by zone and/or ID number) the exact device you wish to replace, for
example: "Z01: Motion Sensor > ID No. 120-1254" and press the button.
[4]
The display prompts you . To delete the device, press the (OFF) button.
3.4.4 Modifying or Reviewing a Device
To Modify or Review the device parameters proceed as follows:
Step 1

Step 2

Step 3

Step 4

Step 5
Select "MODIFY
DEVICES" Option
[1]
Select the respective
device Group
[2]
Select exact device
you wish to modify
[3]
Select the Parameter
you wish to modify
[4]
Modify
the
Parameter
 


 
See  [4]
When
done


 to Step
3

 – Modifying or Reviewing a Device
[1]
Enter the Installer Menu, select the "02.ZONES/DEVICES" option (see section 3.2) and then select the
"MODIFY DEVICES" option.
[2]
Select the respective Group of the device you wish to review or modify i.e. "CONTACT SENSORS", "MOTION
SENSORS", "GLASSBREAK SENS.", "SMOKE SENSORS", "CO SENSORS", "GAS SENSORS", "FLOOD SENSORS",
"TEMPERATURE SENS", "WIRED SENSORS", "KEYFOBS", "KEYPADS" and "SIRENS". For example, "MOTION
SENSORS".
[3] Scroll the Device Group, identify (by zone and/or ID number) of the exact device you wish to modify or review,
for example:
"Z10: Motion Camera > ID No. 140-1737".
[4] From here on the process is same as the configuration process that follows the enrollment of that device. To
continue, refer to Section 3.4.2 "Adding a New Wireless Device" Part B Step 6. When done, the display will
show the next device of the same type (i.e. "Motion camera").
Z10:DEV SETTINGS
Z10:SET CHIME
Z10:ZONE TYPE
Z10:LOCATION
ID No. 140-1737
Z10:Motion Camra MOTION SENSORS
CONTACT SENSORS
MODIFY DEVICES
02.ZONES/DEVICES
<OFF> TO DELETE