Watlow ez-zone pm - Conventions Used in the Menu Pages

Watlow EZ-ZONE
®
PMI Controller • 63 • Chapter 4 Home Page
Possible
Home Page Defaults
(Dependent on Part Number)
Home
Page
Display
Parameter Page and Menu
13 Autotune (2)
aUt2
Operations Page, Loop Menu
14 Idle Set Point (2)
id.s2
Operations Page, Loop Menu
15 Low Set Point
LL.s1
Operations Page, Limit Menu
17 Profile Start
p.st1
Operations Page, Profile Status
18 Action Request
p.aC1
Operations Page, Profile Status
19 None
20 None
Note:
The numerical digit shown in the prompts (last digit) and within the parenthesize above,
represents the parameter instance and can be greater than one.
Conventions Used in the Menu Pages
To better understand the menu pages that follow review the naming conventions used. When
encountered throughout this document, the word "default" implies as shipped from the fac-
tory. Each page (Operations, Setup, Prole and Factory) and their associated menus have
identical headers dened below:
Header Name Definition
Display
Visually displayed information from the control.
Parameter Name
Describes the function of the given parameter.
Range
Defines options available for this prompt, i.e., min/max values (numerical), yes/no,
etc... (further explanation below).
Default Values as delivered from the factory.
Modbus Relative Ad-
dress
Identifies unique parameters using either the Modbus RTU or Modbus TCP protocols
(further explanation below).
CIP (Common Indus-
trial Protocol)
Identifies unique parameters using either the DeviceNet or EtherNet/IP protocol
(further explanation below).
Profibus Index Identifies unique parameters using Profibus DP protocol (further explanation below).
Parameter ID Identifies unique parameters used with other software such as, LabVIEW.
Data Type R/W
uint = Unsigned 16 bit integer
dint = Signed 32-bit, long
string = ASCII (8 bits per character)
float = IEEE 754 32-bit
RWES = Readable
Writable
EEPROM (saved)
User Set (saved)