Watlow ez-zone pm - Chapter 8: Factory Page

Watlow EZ-ZONE
®
PMI Controller • 168 • Chapter 8 Factory Page
Chapter 8: Factory Page
8
CUSt
FCty Custom Setup Menu
1
CUSt Custom Setup (1 to 20)
par Parameter
iid Instance ID
LoC
FCty Security Setting Menu
LoC.o Operations Page
LoC.P Profiling Page
pas.E Password Enabled
rLoC Read Lock
SLoC Write Security
LoC.L Locked Access Level
roLL Rolling Password
pas.u User Password
pas.a Administrator Password
ULoC
FCty Security Setting Menu
CodE Public Key
pass Password
diAg
FCty Diagnostics Menu
Pn Part Number
rEu Software Revision
S.bLd Software Build Number
Sn Serial Number
dAtE Date of Manufacture
ip.aC IP Actual Address Mode
ip.a1 IP Actual Address Part 1
ip.a2 IP Actual Address Part 2
Navigating the Factory Page
To navigate to the Factory Page follow the steps below:
1. From the Home Page, press and hold both the Advance ‰ and Innity ˆ keys for six sec-
onds.
2. Press the Up ¿ or Down ¯ key to view available menus.
3. Press the Advance Key ‰ to enter the menu of choice.
4. If a submenu exists (more than one instance), press the Up ¿ or Down ¯ key to select and
then press the Advance Key ‰ to enter.
5. Press the Up ¿ or Down ¯ key to move through available menu prompts.
6. Press the Infinity Key ˆ to move backwards through the levels: parameter to submenu, sub-
menu to menu, menu to Home Page.
7. Press and hold the Infinity Key ˆ for two seconds to return to the Home Page.
On the following pages, top level menus are identified with a yellow background color.
Note:
Some of these menus and parameters may not appear, depending on the controller's op-
tions. See model number information in the Appendix for more information. If there is
only one instance of a menu, no submenus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon
controller part number.