Watlow ez-zone pm - Chapter 5: Operations Page

Watlow EZ-ZONE
®
PMI Controller • 67 • Chapter 5 Operations Page
5
Chapter 5: Operations Page
Ai
opEr Analog Input Menu
1
Ai Analog Input (1 to 2)
Ain Analog Input Value
i.Er Input Error
i.CA Calibration Offset
d.bi
opEr Digital Bus Menu
1
d.bi J1939 Instance (1 to 6)
vALU Input Value
i.Er Input Error
o.u Output Value
Err Output Error
Lnr
opEr Linearization Menu
1
Lnr Linearization (1 to 2)
Su.a Source Value A
ofst Offset
o.u Output Value
Pu
opEr Process Value Menu
1
Pu Process Value (1 to 2)
Su.A Source Value A
Su.b Source Value B
oFSt Offset
o.u Output Value
PM Operation Page Parameters
To navigate to the Operations Page, follow the steps below:
1. From the Home Page, press both the Up ¿ and Down ¯ keys for three seconds.
Ai
will ap-
pear in the upper display and oPEr will appear in the lower display.
2. Press the Up ¿ or Down ¯ key to view available menus.
3. Press the Advance Key ‰ to enter the menu of choice.
4. If a submenu exists (more than one instance), press the Up ¿ or Down ¯ key to select and
then press the Advance Key ‰ to enter.
5. Press the Up ¿ or Down ¯ key to move through available menu prompts.
6. Press the Infinity Key ˆ to move backwards through the levels: parameter to submenu, sub-
menu to menu, menu to Home Page.
7. Press and hold the Infinity Key ˆ for two seconds to return to the Home Page.
On the following pages, top level menus are identified with a yellow background color.
Note:
Some of these menus and parameters may not appear, depending on the controller's op-
tions. See model number information in the Appendix for more information. If there is
only one instance of a menu, no submenus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon
controller part number.