Watlow ez-zone pm - Modbus TCP or Ethernet;Ip

Watlow EZ-ZONE
®
PMI Controller • 151 • Chapter 6 Setup Page
Setup Page
Display
Parameter Name
Description
Range Default
Modbus
Relative Ad-
dress
CIP -
Class
Instance
Attribute
hex (dec)
Pro-
fibus
Index
Param-
eter
ID
Data
Type
and
Access
**
Modbus TCP or EtherNet/IP
ЛЏ.hL
M.hL
Communications (2)
Modbus Word Order
Select the word
order of the two
16-bit words in the
floating-point val-
ues.
Lohi Low-High
(1331)
hiLo High-Low
(1330)
Low-High Instance 1
Map 1 Map 2
2488 2968
Instance 2
Map 1 Map 2
2508 2988
0x96
(150)
1 to 2
5
- - - - 17043 uint
RWE
iP.ЛЏ
iP.M
Communications (2)
IP Address Mode
Select DHCP to let a
DHCP server assign
an address to this
module.
dhCP DHCP (1281)
F.Add Fixed Address
(1284)
DHCP - - - - - - - - - - - - 17012 uint
RWE
Note:
When changing IP address, the control power must be cycled for the new address to take effect.
iP.F1
ip.F1
Communications (2)
IP Fixed Address
Part 1
Set the IP address
of this module.
Each device on the
network must have
a unique address.
0 to 255 169 - - - - - - - - - - - - 17014 uint
RWE
iP.F2
ip.F2
Communications (2)
IP Fixed Address
Part 2
Set the IP address
of this module.
Each device on the
network must have
a unique address.
0 to 255 254 - - - - - - - - - - - - 17015 uint
RWE
iP.F3
ip.F3
Communications (2)
IP Fixed Address
Part 3
Set the IP address
of this module.
Each device on the
network must have
a unique address.
0 to 255 1 - - - - - - - - - - - - 17016 uint
RWE
* These parameters/prompts are available in these menus with firmware revisions 11.0 and above.
** R: Read, W: Write, E: EEPROM, S: User Set