Watlow ez-zone pm - Starting a Profile

Watlow EZ-ZONE
®
PMI Controller • 157 • Chapter 7 Profiling Page
Once these global prole features are congured, the next step will require navigation to
the Proling Page. Here, each desired ramp and soak prole will be congured.
To navigate to the Prole Page from the front panel, follow the steps below:
1. From the Home Page, press and hold the Advance Key ‰ for approximately ve seconds.
The prole prompt prof will appear in the lower display and the prole number (e.g.
p1) appears in the upper display.
2. Press the Up ¿ or Down ¯ key to change to another prole (1 to 4).
3. Press the Advance Key ‰ to move to the selected proles rst step.
4. Press the Up ¿ or Down ¯ keys to move through and select the step type.
5. Press the Advance Key ‰ to move through the selected step settings.
6. Press the Up ¿ or Down ¯ keys to change the steps settings.
7. Press the Innity Key ˆ at any time to return to the step number prompt.
8. Press the Innity Key ˆ again to return to the prole number prompt.
9. From any point press and hold the Innity Key ˆ for two seconds to return to the Home
Page.
If using EZ-ZONE Congurator software, simply click on the plus sign next to Proles in the
left hand column, as
shown in the screen
shot below.
Notice in the screen
shot to the right some
elds or parameters
are not selectable
(grayed out) based on
the Step Type that is
selected.
Starting a Profile
There are several
ways to start a prole.
Some of the examples
that follow requires
that certain optional
hardware be avail-
able on the control. If
you are uncertain as
to how your control is
equipped, compare the
part number of your
control to the "Order-
ing Information" page
found in the Appendix
of this Users Guide.
Three ways to start a prole:
- Function Key, Digital Input or Prole Request