Watlow PM PLUS™ 6 • 48 • Chapter 5: Setup
Setup Lists
You will not see every parameter listed here. These vary depending on the features enabled on your device.
Offset Digital Bus (1 to 4) -1,999.000 to 9,999.000 1.0 93010
Filter Digital Bus (1 to 4) -1,999.000 to 9,999.000 1.0 93011
CAN Units Digital Bus (1 to 6) °F (30)
°C (15)
None
Instance 5 =
None, instance
1,2,3,4, 6 = C
93021
Output Error Output Error None (61)
Open (65)
Shorted (127)
Measurement Error (140)
Bad Calibration Data (139)
Ambient Error (9)
RTD Error (141)
Fail (32)
Math Error (1423)
Not Sourced (246)
Stale (883)
Stale 95004
Action Function Select the function that will be triggered by a
true state for Digital Inputs 5 or 6.
None (61)
Start Step (1077)
Profile Start/Stop, level trig-
gered (208)
Start Profile, edge triggered
(196)
Profile Hold/Resume, level
triggered (207)
Profile Disable, level trig-
gered (206)
TRU-TUNE+
Disable, level
triggered (219)
Switch Control Loop Off,
level triggered (90)
Manual, level triggered (54)
Tune, edge triggered (98)
Idle Set Point, level trig-
gered (107)
Force Alarm, level triggered
(218)
Control Loops Off and
Alarms to Non-alarm State,
level triggered (220)
Silence Alarms, edge trig-
gered (108)
Alarm Reset, edge triggered
(6)
Keypad Lockout, level trig-
gered (217)
User Set Restore, edge trig-
gered (227)
Remote Set Point (216)
None 10003
Function Instance Select which Digital Input will be triggered by
a true state.
0 to 40 0 10004
To Next Page
Loading...
Need help?
General
