Watlow PM PLUS 6 User Manual

Watlow PM PLUS™ 6 • 9 • Chapter 1 Overview
Chapter 1: Overview
Introduction
Watlow’s PM PLUS™ has an intuitive interface with a smooth touch keypad for easy programming and read-
ability. This reduces complexity at the front of the control. Using Composer or Configurator is highly desir-
able to program the PM. The PM PLUS™ is compatible with legacy EZ-ZONE PM controllers and connects via
Bluetooth
®
to our EZ-LINK™ mobile app for remote access configuration and monitoring, if Bluetooth
®
was
ordered in the Part number.
The PM PLUS™ can be ordered as a PID controller or an integrated controller with multiple functions
combined. Look for the device configuration code on the product label to confirm which functional options are
included on your device. Upon power up, you can see the firmware revision and Bluetooth
®
logo, if enabled, on
the device display and if Bluetooth
®
is part of the Part number.
Standard Features and Benefits
Intuitive list flow
• Reduces menu structure to a list of lists for easy configuration
• Offers easy to read characters and color coding for a display visible from many angles
• Reduces setup time and increases operator efficiency
Smooth touch keypad
• Eliminates contamination points on the front of the controller and creates better seal
• No mechanical components to wear out, easy to clean
Bluetooth
®
compatible with EZ-LINK™ mobile app
• Provides full descriptions of parameters and error codes
• Allows remote access capabilities without the use of cables or converters
• Provides the ability to configure the product and save parameter sets, except for Factory parameters and Profile
parameters.
High amperage integrated PID and limit controller
• Reduces wiring time and termination complexity compared with connecting other products
• Decreases component count and required panel space
• Increases user and equipment safety for over/under temperature conditions
• Drives 15 ampere resistive loads directly
Standard Bus Communications with Configuration Software
• Includes Watlow standard bus communications used by COMPOSER
®
or CONFIGURATOR
®
software
Serial communication capabilities
• Provides a wide range of protocol choices including Modbus
®
RTU, EtherNet/IP™, Modbus
®
TCP, PROFIBUS DP,
DeviceNet™ and J1939 CAN bus
• Supports network connectivity to a PC or PLC for remote set point adjustment

Watlow PM PLUS 6 Specifications

General

Brand	Watlow
Model	PM PLUS 6
Category	Controller
Language	English