14
This chapter defines the contents and purposes of this manual and
describes the main characteristics of the CFW-10 frequency inverter.
Identification, receiving inspections and storage requirements are also
provided.
This Manual is divided into 9 Chapter, providing information to the
user on receiving, installation, start-up and operation:
Chapter 1 - Safety Notices.
Chapter 2 - General Informations and Receiving the CFW-10.
Chapter 3 - CFW-10 and RFI Filters - Mechanical and Electrical
Installation (power and control circuitry).
Chapter 4 - Using the Keypad (Human Machine Interface - HMI).
Chapter 5 - Start-up - Steps to follow.
Chapter 6 - Setup and Read-only Parameters-Detailed description.
Chapter 7 - Solving problems, cleaning instructions and preventive
maintenance.
Chapter 8 - CFW -10 Optional Devices - Description, technical
characteristics and installation.
Chapter 9 - CFW-10 ratings - Tables and technical information.
This Manual provides information for the correct use of the CFW-10.
The CFW-10 is very flexible and allows theoperation in many different
modes as described in this manual.
As the CFW-10 can be applied in several ways, it is impossible to
describe here all of the application possibilities. WEG does not accept
any responsibility when the CFW-10 is not used according to this
Manual.
No part of this Manual may be reproduced in any form, without the
written permission of WEG.
It is important to note the Software Version installed in the CFW-10,
since it defines the functions and the programming parameters of the
inverter.
This manual refers to the software version indicated on the inside
cover. For example, the Version 1.0X applies to versions 1.00 to 1.09,
where “X” is a variable that will change due to minor software revisions.
The Software Version can be read in the Parameter P023.
GENERAL INFORMATION
2.1 ABOUT THIS
MANUAL
2.2 SOFTWARE
VERSION
CHAPTER 2
To Next Page
Loading...
