25
CHAPTER 3 - INSTALLATION AND CONNECTION
Figure 3.2 and table 3.2 show free space requirements to be left
around the drive.
Install the drive on a vertical position, following the recommendations
listed below:
1) Install the drive on a flat surface.
2) Do not install heat sensitive components immediately above the
drive.
ATTENTION!
When there are other devices installed at the top and at the bottom of
the drive, respect the minimum recommended distance (A + B) and
deflect the hot air coming from the device below.
ATTENTION!
Provide independent conduits for signal, control and power
conductors. (Refer to Electrical Installation). Separate the motor cables
from the other cables.
3.1.3 Mounting
Specification
3. Use (M4) mounting screws in order to fasten the frequency inver-
ter to the base plate.
4. After drilling the holes, clean the contact surface of the backing
plate and coat it with a thin thermal paste layer, or with a heat
conducting foil or similar product (approx. 100 m).
5. Continue the mechanical installation as indicated in Chapter 3.1.
6. Electrical installation shall be performed as indicated in the
Chapter 3.2.
ATTENTION!
After operation, check P008. This parameter must not exceed 90 ºC.
Figure 3.2 - Free-space for Cooling
To Next Page
Loading...
