21
CHAPTER 2 - GENERAL INFORMATION
2.5 RECEIVING
AND STORING
The CFW-10 is supplied in cardboard boxes.
There is a nameplate on the outside of the packing box that is identical
to that one on the CFW-10.
Check if the:
CFW-10 nameplate data matches with your purchase order.
The equipment has not been damaged during transport.
If any problem is detected, contact the carrier immediately.
If the CFW-10 is not installed immediately, store it in a clean and dry
room (storage temperatures between -25 °C and 60 °C). Cover it to
protect it against dust, dirt or other contamination.
ATTENTION!
When stored for a long time, it is recommended to power up and
keep the drive running for 1 hour every year. Make sure to use a single-
phase power supply (50 or 60 Hz) that matches the drive rating without
connecting the motor to its output. After powering up the drive, keep it
off for 24 hours before using it again.
To Next Page
Loading...
