WEG CFW-10 - Chapter 3 Installation and Connection; Mechanical Installation

CONTENTS
3.3.2 Specification of the Emission and
Immunity Levels ................................................. 40
3.3.3 Inverter and Filters ............................................. 41
3.3.4 Characteristics of the EMC Filters ..................... 43
CHAPTER 4
Keypad (HMI) Operation
4.1 Keypad (HMI) Description ....................................... 47
4.2 Use of the Keypad (HMI) ......................................... 48
4.2.1 Keypad (HMI) Operation .................................... 48
4.2.2 Inverter Status - HMI Display .............................. 49
4.2.3 Read-Only Variables ......................................... 50
4.2.4 Parameter Viewing and Programming ............... 50
CHAPTER 5
Start-up
5.1 Pre-Power Checks ................................................. 52
5.2 Initial Power-up ....................................................... 52
5.3 Start-up ................................................................ 53
5.3.1 Start-up Operation via Keypad (HMI) .................. 53
5.3.2 Start-up Operation via Terminals ........................ 54
CHAPTER 6
Detailed Parameter Description
6.1 Symbols ................................................................ 55
6.2 Introduction ............................................................. 55
6.2.1 V/F (Scalar) Control .......................................... 55
6.2.2 Frequency Reference Sources .......................... 56
6.2.3 Commands ....................................................... 59
6.2.4 Local/Remote Operation Modes ........................ 59
6.3 Parameter Listing ................................................... 60
6.3.1 Access and Read Only Parameters -
P000 to P099 ................................................... 61
6.3.2 Regulation Parameters - P100 to P199.............. 62
6.3.3 Configuration Parameters - P200 to P398 ......... 71
6.3.4 Special Functions Parameters - P500 to P599 ... 88
6.3.4.1 Introduction............................................... 88
6.3.4.2 Description .............................................. 88
6.3.4.3 Start up Guide .......................................... 91