Appliances
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
4•103
Clean the interior with mild detergent and warm water. Avoid the use of
solvent cleaning agents or abrasives on the interior. These cleaners may
transmit taste to the ice cubes and food, or damage and discolor the interior.
The exterior may be cleaned with mild detergent and warm water. The front
grill should be kept free of dust and lint to permit free air flow to the con-
denser. The condenser coil, located behind the front grill, should be cleaned
three to four times each year. Clean more often if traveling with pets. Use a
brush or vacuum cleaner to remove dirt, lint and other accumulations from
the condenser coil.
See the Manufacturer’s Instructions located in the
motorhome’s Information File for specific operating instruc-
tions.
The water is electrically heated to a brewing/cooking hot 190° F (88° C) by
a compact tank that mounts under the sink. A thermostat maintains the water at
this approximate temperature. When you turn the tap, cold water enters the bot-
tom of the tank and forces hot water out of the faucet. The
system is vented so the tank is not pressurized.
Operation
Locate the power cord and plug it into a 120V receptacle.
It will take 10 to 15 minutes for water to reach 190° F (88°
C) in temperature. Steam or hot water may come out of the
faucet without turning it on. After 10 to 15 minutes turn on
the faucet for about 20 seconds to bleed off any steam until
the hot water is dispersed. Allow the water in the tank to
reheat. Repeat this step one or two times. When hot water
with no steam is dispensed, turn the faucet on to use hot
water. To shut off the system, unplug the power cord.
Temperature Adjustment
If the steam cannot be stopped, or the water boils, adjust
temperature as follows:
• Unplug the power cord.
• Remove the screw and access cover.
• Insert a screwdriver in the slot of the thermostat
adjusting screw and turn clockwise a 1/2 notch to
increase the water temperature, or counterclockwise a
1/2 notch to decrease the water temperature.
• Reinstall the access cover and plug the power cord into
a 120V receptacle.
U-Line Ice Maker front grill. To
remove front grill, unscrew the
Phillips screw.
Care & Cleaning
HOT WATER
DISPENSER
(Optional)
To Next Page
Loading...
Need help?
General