Appliances
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
4•110
The exterior of the oven is plastic and metal. The interior is metal. Do not use
scouring pads, harsh or abrasive cleanser, chemical cleaners or petroleum based thin-
ners as these can damage the finish. Use mild soap and water with a damp cloth or
paper towel to remove most stains or spills. When cleaning the touch pad, open the
door to prevent accidental operation. Use mild soap and water with a soft cloth. Avoid
using excess amounts of water on the touch pad. The turntable plate and oven racks
are dishwasher safe.
Grease Filters:
Do not operate the oven without the grease filters in place. This can damage the
microwave. Grease filters should be cleaned at least once a month. To remove the fil-
ters, use the pull tab to slide the filter to the end of the opening and tip down. Soak
the filters in the sink or in a dishpan filled with hot water and detergent.
• Do not use ammonia or other alkali based products. They may darken
the filter material.
• Agitate the filter. Use a scrub brush to remove caked on grease.
• Rinse the filter thoroughly and shake it dry. Place the filter back into the
opening, tip it upward and slide it to the end of the opening. Lock it in
place. Be careful not to kink or warp the filter upon installation.
Cooktop burners use 110 Volt AC electronic ignition to light the burners. To supply
current to the cook top turn the inverter on, hook to shore power or start the generator.
To conserve energy, preheat the pans only when recommended and shorten the
cooking time by using the least amount of water possible. Do not let the flame extend
beyond the cooking utensil. When cooking, heat the food on a higher heat setting then
turn the heat down to finish cooking.
To Light the Burners:
1. Make sure the LP-Gas is turned on.
2. Push down the knob and turn it counter
clockwise to the ignite position.
3. Hold the knob down fully until the spark
ignites the gas and until the thermocouple is
heated (approximately 5 to 10 seconds). This
will activate the safety magnet and keep the
burner lit.
4. Release the knob and set the flame to the
desired setting.
5. Turn the knob clockwise to turn it off.
NOTE: All electric cook tops require burners to be heated 3-5 seconds
before use.
Care & Cleaning
COOKTOP
To Next Page
Loading...
Need help?
General