Appliances
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
4•112
Regular cleaning with a soft cloth and a warm detergent solution is gener-
ally enough to keep the cooktop clean. Wash, rinse and dry with a soft cloth.
Thoroughly clean the cooktop when it is cool. Use a dry cloth or paper towel
while the surface is warm to the touch to clean splatters or spills. Cleaning will
be more difficult if spills bake on to the surface. Glass cleaner sprayed on a
paper towel should be used for the cooktop surface. Do not spray glass cleaner
directly on the surface. DO NOT use abrasive cleaners or steel wool. harsh
cleaners like bleach, ammonia and oven cleaner should NEVER be used. The
surface burner grate and caps should be cleaned using the same guidelines as
the cooktop surface.
Porcelain enamel is a type of glass fused on steel at a very high tempera-
ture. It is not extremely delicate but must be treated as glass. Sharp blows, radi-
cal surface temperature changes, etc., will cause enamel to chip or crack. Some
foods such as vinegar, lemon juice, tomatoes and milk contain acids which can
dull the finish of the enamel. To avoid dulling the finish, wipe up the spill
before it is baked on. The surface is glass and must be given consideration
when cleaning. Steel wool and coarse, gritty cleanser will scratch or mar the
surface. Any gentle kitchen cleanser powder or grease cleaner will be suitable.
For further information on care and maintenance of the porcelain, call”Hopes
Cultured Marble Polish” at 800-325-4026.
The motorhome is equipped with two 13,500 BTU roof air conditioners. The
roof air conditioners operate from 120 Volts AC only, either by shore power or
the generator. Operations are controlled by the 12 Volt DC comfort control.
The electronics in the comfort control use a type of telephone patch cord to
send a low voltage signal to the roof air conditioner’s circuit board. The circuit
board controls the desired roof air functions and LP-Gas furnace operation. The
refrigeration process in the roof air, primarily the same as the dash air condi-
tioner or a household type refrigerator, functions as an enclosed system. The
refrigeration process repeats in a cycle. The refrigerant is drawn into the com-
pressor. The high pressure vapor is sent to a condenser where the heat is
expelled into the atmosphere. The vapor leaves the condenser as a high pressure
liquid. This liquid is forced into a metered capillary tube and then into the evap-
orator or low side pressure. The refrigerant changes from liquid form to vapor
as the heat is extracted. The vapor is drawn back into the compressor to start
the cycle again. When operating the roof air in the heat pump mode, the refrig-
erant flow is reversed blowing the heated air into the interior of the motorhome.
NOTE: Air conditioning systems will freeze the moisture in
the air depending on the humidity content. Under high
humidity conditions it is recommended to set the blower fan
to HIGH speed.
Porcelain Enamel
AIR CONDITIONER
ROOF
To Next Page
Loading...
Need help?
General