This is an alternate field of main system status. To access the various
meters available, depress the UP arrow button and hold for five seconds. The
RC7 GS remote will beep. Release the button. The Avg Shunt Amps will be
displayed. This field area includes:
Avg Shunt Amps: This measures the DC current either charging
or discharging. Most of the house DC current usage is moni-
tored by the inverter.
Battery Voltage: This monitors the house battery voltage.
Inv/Chg Current: This measures the AC current usage when
the inverter is charging.
Inverter Output VAC: This monitors the AC output voltage
while the unit is inverting.
AC Input Amps: The inverter uses a double pole pass through
relay. This measures current consumption through the Hot 1
terminal.
Battery Temperature: This monitors counts of the battery tem-
perature sensor (BTS). Counts are measured impulses which
the inverter uses to calculate the battery case temperature. The
charging voltage is adjusted to optimum values.
Xformer Temp: This monitors the transformer temperature
which is measured in counts. Higher count readings are regis-
tering lower temperatures.
FET Temp: This monitors the Field Effect Transistor tempera-
ture which is measured in counts.
Est Batt Cap: This estimates the battery bank capacity in amp
hours (Ahrs). Charging and discharging on a cyclic basis will
give an approximate indication of the battery capacity in amp
hours. Observe the reading and multiply by eight to obtain an
approximate reserve capacity. This figure is only approximate
and will change with cyclic use.
Electrical Systems - House
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR 8•199
Meter Menu
To Next Page
Loading...
Need help?
General