EasyManua.ls Logo

Windsor Monaco - Water Filter

Windsor Monaco
318 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The water pump is noisy or rough in operation:
• Check for plumbing which may have vibrated loose.
• Does the mounting surface multiply noise (flexible)?
• Check for mounting feet that are loose or compressed too tight.
• Look for loose pump head to motor screws.
The water pump is rapid cycling:
• Look for restrictive plumbing/flow restrictors in the faucets or shower
heads.
You need to replace filter with diverter cap before you disinfect water system with a
chlorine solution. To change filter or replace filter with diverter cap use the following
procedure.
To Remove:
• Turn off water supply and water pump then open faucet to bleed off pressure.
• Lift locking lever up to a vertical position.
• Turn locking ring all the way left.
• Turn cartridge or diverter cap all the way left and pull down to remove.
To Install:
• Check that locking ring is all the way left and down. Align bump on
cartridge or diverter cap with opening in a locking ring. Push new cart-
ridge or diverter cap up into base and turn right until it stops.
• Turn locking ring right until it stops and lower locking lever so that it
locks ring.
• Turn on water pump or city water.
Water Systems
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
6•164
WATER FILTER

Table of Contents