inconspicuous area in case an undesired reaction occurs. Observe the test
area from different angles checking for hazing or swirl marks. If an abnormal
reaction to the finish results, discontinue product use and consult the prod-
uct’s manufacturer. If the product is a paste, do not allow dried paste to be
baked on by the sun. Remove paste shortly after drying. Clean, dry, 100%
cotton cloths or cotton baby diapers are best suited for the removal of dried
paste. Turn the cloth often. Use a separate clean cloth to buff. The surface
should feel “slick” when rubbing the cloth lightly over it. Avoid repeated
wax applications which can cause wax to build up. Some very fine scratches
or swirl marks may be removed by an application of a glaze. These types of
glazes fill the scratches or swirl marks.
The motorhome has a large surface area. Washing and waxing may not be
completed in one afternoon. Select sections to wax until the motorhome is
complete. If the task seems formidable, have an automotive detailer perform
the task.
Road oil will cause deterioration of the rubber. Dirt buildup will help hold
chemicals in the air next to the tire and will also cause deterioration.
When cleaning any rubber product, proper care and methods in cleaning
must be used to obtain the maximum service years out of the tires. Use a soft
brush and a mild detergent to clean the tires. If a dressing product is used to
“protect” the tires from aging, use extra care and caution. Tire dressings that
contain petroleum products or alcohol may cause deterioration or cracking.
In many cases it is not the dressing that causes a problem, but the chemi-
cal reaction that subsequently occurs. When these same dressing products are
used on a passenger car tire that is replaced every three to four years, it is
rare to see a major problem. However, in most cases, RV tires may last
longer due to limited annual mileage, and exposure.
• Clean frequently with high pressure water from a hose. The use of mild
detergent will speed the cleaning process. Do not use harsh alkalis,
alcohol or acidic cleansers. A secondary hand washing with a soft cloth
may be required to remove some stubborn road films.
• When the tires are removed, the entire wheel must be cleaned and
inspected. With a wire brush or sandpaper remove dirt, corrosion or any
foreign materials from the tire side of the rim. Do not use a wire brush
or other abrasive substances to remove dirt and corrosion on the pol-
ished surface of the wheel.
• To maintain the original appearance of the aluminum wheels the follow-
ing procedures are recommended:
1. After installing new wheels (prior to operating your motorhome)
use a sponge, cloth or soft fiber brush to wash the exposed wheel sur-
faces with a mild detergent/warm water solution.
Care & Maintenance
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
3•71
Care & Maintenance
of Aluminum Wheels
Tire Care
To Next Page
Loading...
Need help?
General