Before using the washer for the first time, wipe the inside and outside with a
damp cloth to remove any travel dust that has accumulated. Operating a rinse
cycle to rinse out the washer is recommended. Front load, horizontal axis wash-
ing machines require less detergent. Soap suds line should not exceed the
halfway point of the glass door.
To begin a wash load:
• Sort and pre-treat clothes.
• Add the measured amount of detergent suggested by the package
directions (maximum two tablespoons).
• Load the clothes loosely into the washer. Close the washer door.
• Turn the cycle selector knob to the desired temperature setting.
• Decide which washing cycle you wish to use. Turn the timer
knob clockwise to the desired wash setting.
• Select High or Medium spin (only for regular washing).
• Press the push button ON.
• After the cycle is complete, wait two minutes for the door lock to
release before attempting to open the door.
WARNING: Do not wash or dry articles that have previously
been cleaned, washed, soaked or spotted with gasoline, dry
cleaning solvents or other flammable or explosive substances.
Do not add these substances to the wash water as they pro-
duce vapors that could ignite or explode. Do not use dryer to
dry articles containing foam rubber or similar textured, rub-
ber-like materials. Clean the lint screen after each use (if
applicable), located in the top left corner on the back of the
washer. Keep the area around the exhaust opening and adja-
cent areas free from lint, dust and dirt accumulation.
The removable drain screen, which protects the pump from lint and
foreign matter, needs to be cleaned periodically. The frequency in which
it is cleaned depends upon the type of clothes that are washed. Cotton
articles produce more lint than nylon articles. Under no circumstance
should the drain screen be removed while the machine is full of water. To
clean the drain screen on an empty machine, open the service door by
pressing on the left hand side. Place a cloth or shallow tray under the
drain screen housing to catch any remaining water that may drip out. It
may be helpful to first set the machine to spin, then remove the drain
screen. This procedure reduces the amount of water released. Turn the
drain screen counterclockwise and pull the drain screen out. Clean the
screen to remove any dirt and lint. To replace the screen, slide it back into
the housing and turn it clockwise to secure. Close the service door.
NOTE: Check for water leaks before using the washer
after removing and replacing the drain screen.
Appliances
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
4•124
Operating
Instructions
Cleaning the
Drain Screen
To Next Page
Loading...
Need help?
General