The Red LED will flash and the alarm will sound whenever a dangerous
level of propane or methane gas is detected. The detector will continue to
alarm until the gas clears or the Mute switch is pressed.
Procedures To Take During An Alarm:
1. Turn off all gas appliances (stove, heaters, furnace),
extinguish all flames and smoking material.
Evacuate, leave doors and windows open.
2. Turn off the propane tank valve.
3. Determine and repair the source of the leak. Seek
professional help if necessary.
CAUTION: Do Not re-enter until the problem is corrected.
Alarm Mute
Press the Test-Mute button when the detector is in alarm.
1. The Red LED will continue flash and the alarm will
beep every 30 seconds until the gas level has
dropped to a safe level.
2. The LED will flash Green until the end of the Mute
cycle.
3. If dangerous gas levels return before the end of the
mute cycle the alarm will beep 4 times and return to
phase 1.
4. After 2 minutes the detector will return to normal
operation (solid Green) or resound the alarm if dan-
gerous levels of gas remain in the area.
Fault Alarm
Should the microprocessor sense a fault in the gas detector, a fault alarm
will sound twice every 15 seconds. The LED will alternately flash Red to
Green and the MUTE switch will not respond to any command. The gas
detector must be repaired or replaced.
1. Vacuum the dust off the detector cover weekly (more
frequently in dusty locations) using the soft brush
attachment of your vacuum.
2. Do not spray cleaning agents or waxes directly onto
the front panel. This action may damage the sensor,
cause an alarm or cause a detector malfunction.
LP-Gas System
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR 7•181
Care of
the Detector
To Next Page
Loading...
Need help?
General