EasyManuals Logo

Windsor Monaco User Manual

Windsor Monaco
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #138 background imageLoading...
Page #138 background image
2. Press and hold the slide-out room switch in the OUT position.
The slide-out room will move slowly to the OUT position. The
drive motor will not stop automatically. To stop the slide-out
room before reaching the OUT position, release the switch. To
continue room movement, push and hold the switch in.
3. Release the switch, which will lock the room into position.
CAUTION: Dirt and grit trapped under the slide could result in
damage to the floor. Continuous operation of the slide-out could
cause a drain on the house batteries and damage to the slide
motor from overheating.
CAUTION: Remove the slide lock bars before moving the slide-
out room. Damage can result if it is left in position. The manufac-
turer is not responsible for damage resulting from operating the
slide-out room with the slide lock bars left in position.
NOTE: Do not leave the slide-out in the extended position during
severe weather. Conditions such as high winds or heavy rain may
cause damage to an extended slide-out.
NOTE: Perform the slide-out room operation with the air suspen-
sion system full. Extensive damage could occur to the slide room
and awning when extending the slide room in snow, sleet, ice or
freezing rain conditions. In such conditions,if the slide-out room
is already extended, clear the awning and ensure free movement
prior to operating the slide room.
To Retract the Bedroom Slide:
1. Ensure there is sufficient clearance inside motorhome for the slide-out
room.
2. If applicable, clean the floor.
3. Remove any debris from the top of the slide-out room.
4. Press and hold switch to the IN position. To stop the slide-out room
before it fully retracts, release the switch. To continue the room move-
ment, push and hold the switch in.
5. When the room is fully retracted, release the switch. The room will lock
into position.
6. After the slide-out room is retracted, place the two turnbuckle locking
bar mechanisms between the wall and top edge of the slide-out room
and lock it into place.
Equipment
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
5•138
Retracting Bedroom

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Windsor Monaco and is the answer not in the manual?

Windsor Monaco Specifications

General IconGeneral
Fuel TypeGasoline
GPS NavigationOptional
WiFiOptional
Solar PanelOptional
ChassisFord
Sleeping Capacity4
HeatingForced-air furnace
Refrigerator2-way
Stove3-burner
MicrowaveYes
Audio SystemAM/FM/CD/DVD
ShowerYes
SinkYes
FlooringVinyl
SteeringPower steering
Seatbelts4
AirbagsDriver and passenger
BatteriesTwo house batteries
Air ConditioningRoof-mounted
FurnitureDinette, sofa
BluetoothOptional
Warranty1-year limited