Appliances
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
4•122
The water heater by design has an internal air pocket to reduce the
possibilities of dripping or weeping. The expanding of water, in time, will
absorb the air and pocket. The air will have to be replaced utilizing a simple
procedure when this occurs.
CAUTION: Ensure the water heater storage tank is cool
prior to making any check of the valve.
Step 1: Turn OFF the water heater.
Step 2: Shut OFF the incoming water supply.
Step 3: Open the closest hot water line of the motorhome.
Step 4: Pull the handle of the relief valve until the flow of water stops.
Step 5: Allow the relief valve to snap shut, close the hot faucet and turn
ON the water supply.
Step 6: Turn ON the water heater.
The air pocket will have been re-established and will not need to repeat
until the next discharge of water. If the discharge does not stop contact a quali-
fied service center to evaluate the valve and make any required repairs.
To Next Page
Loading...
Need help?
General