EasyManuals Logo

Windsor Monaco User Manual

Windsor Monaco
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #170 background imageLoading...
Page #170 background image
The grey water holding tank valve (small valve) remains open when con-
nected to the sewer hook-up. The black water holding tank valve (large valve)
remains closed at all times except when dumping the sewage tank. When
preparing to dump the black water holding tank, first close the grey water tank
valve. Allow the grey water tank fluid to accumulate until the tank is at least
half full or fill by running cold water through the sink and shower drains. Do
not overfill the grey water holding tank.
To aid in the removal of solids, dump the black tank when the tank is at least
50% full. If it is necessary to dump the black tank when the level is below 50%
add water by using the sewage tank flush system.
• With black valve closed use the sewage tank flush system to
increase the holding tank level.
• When adding water to the tank using the sewage tank flush sys-
tem, closely observe the tank level by using the monitor panel
tank gauge indicator to prevent the tank from being overfilled.
• The sewage tank flush system should never be operated unattend-
ed.
Dumping the Waste Holding Tanks:
• With the grey water valve closed, open the black water valve to
drain the tank.
• Flush the sewage tank. Connect a separate non-potable water sup-
ply hose with pressure regulator to the sewage tank flush connec-
tion on the water service panel. For sanitary reasons, be sure not
use the potable city water hose for this procedure. The large gate
valve remains open throughout the flushing cycle. Turn the water
on and flush the black water system for approximately two min-
utes. Ensure water is flowing freely through the sewer hose.
• When finished flushing the system, turn the water off and close
the black water valve.
• Open the grey water valve.
• The waste water tank is flushed by running two gallons of water
down a sink drain.
• If applicable, close the grey water valve for transit.
• Disconnect and flush the drain hose with either the non-potable
water supply hose or the exterior faucet. Secure the sewer hose in
the travel location. Disconnect and stow the non-potable hose.
• Install the end cap (required by law in some states) and deck plate
when in transit to prevent leakage. Swivel sewer drain pipe up.
NOTE: Periodically lubricate the O-ring on the sewer hose adapter
with silicone spray. Use care when connecting the hose adapter to the
drain pipe in cold weather.
Water Systems
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
6•170

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Windsor Monaco and is the answer not in the manual?

Windsor Monaco Specifications

General IconGeneral
Fuel TypeGasoline
GPS NavigationOptional
WiFiOptional
Solar PanelOptional
ChassisFord
Sleeping Capacity4
HeatingForced-air furnace
Refrigerator2-way
Stove3-burner
MicrowaveYes
Audio SystemAM/FM/CD/DVD
ShowerYes
SinkYes
FlooringVinyl
SteeringPower steering
Seatbelts4
AirbagsDriver and passenger
BatteriesTwo house batteries
Air ConditioningRoof-mounted
FurnitureDinette, sofa
BluetoothOptional
Warranty1-year limited