• Check that the monitor panel is functioning properly.
• Inspect the 120 Volt electrical system which includes the power
cord, inverter/converter all outlets and exposed wiring.
NOTE: Prepare the generator for operation following the
instructions in the Generator Manual.
• Start and run the generator.
• Ensure the batteries are being charged. Operate the 120 Volt appliances
and air conditioners. If an electrical item or appliance is not
functioning properly, contact the dealer or an authorized service
center to have it evaluated.
• Have a qualified technician inspect the LP-Gas system and
perform an LP Gas leak test. The leak test should also include an
LP-Gas regulator adjustment (if needed). The test can also verify
if the regulator is faulty and should be replaced. Have the LP-Gas
tank inspected.
• Operate each LP-Gas appliance. Observe all burner/pilot flames
for proper color and size.
• Inspect and clean the interior.
• Check the sealant around all roof and body seams and windows.
Reseal if necessary.
• Lubricate all the exterior locks, hinges and latches with a graphite
lubricant.
• Check the windshield wiper blade condition. Check the
wiper/washer operation.
• Wash and wax the exterior. Inspect the body for scratches or other
damage; touch up or repair as necessary. Flush the underside
thoroughly.
• Run through the operational checks for steering, brakes, engine
and transmission. Operate the motorhome slowly during these
checks to allow sufficient circulation of fluids and resetting of the
components.
• If desired, have the dealer or repair center double check any
preparation and correct any defects or make any necessary
adjustments.
Care & Maintenance
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
3•93