60 M101M8 Rugged Android Tablet User Guide
• Adjust volume of the tablet computer by pressing
on the volume rocker.
• If using an external audio device, make sure that
the cable is properly connected.
I cannot project the tablet computer
display to another monitor.
• Make sure the VGA driver is installed.
• Make sure the output setting selected is correct.
Barcode scanner does not emit laser
beam and does not seem to work.
• Make sure the Barcode scanner device is detected,
please open WDC application and check Data
Capture “About”.
• If the device is not detected in WDC application
under Data Capture “About”, please press
Reset Setting in Data Capture.
Barcode Scanner emits laser beam but
does not read barcode presented to it.
• Adjust the distance between barcode scanner of
the device and the barcode being scanned.
• Make sure the barcode code type is enabled in the
tablet. To enable/disable a specific barcode code
type, go through the “Barcode Scanner
Battery leaking or swollen
• The lithium battery used in this tablet may swell
after being charged/ discharged many times, but
there is no problem regarding safety.
• Continued use in such a state may result in the
battery getting jammed, so please stop using the
battery, and purchase a new one.
To Next Page
Loading...
